How to Direct Wire Double-Ended LED Tube Lights 4 Lamps Instant Start

With double-ended direct wire LEDs, the line is connected to the lampholders at one end of the fixture, neutral at the other end. shunted or non-shunted lampholders can be used with double-ended LED tubes. double-ended tubes can be reversed in a light fixture just like a fluorescent tube. When using non-shunted lampholders, the wires only need to be connected to one side of the lampholder with most LED tubes (check the wiring instructions).Find Double-Ended LED Tube Lights

Caution! Direct wiring will cause the lampholders to be energized with line voltage when the light switch is turned on. Always turn the power off to the light fixture when installing or replacing tubes in direct wired fixtures.

A fixture modification label should be supplied with the tube. Place this on the ballast cover according to instructions.

Instant Start Ballast 4 Lamps

Factory wiring

LED Direct Wire Double-Ended Wiring Diagram 4 Lamps Instant Start Fixture

Cut the wires from the ballast. Remove the ballast from the fixture (or leave it in place). Using tan wire connector for line and orange wire connector for neutral. Trim wires to about 1/2” for neutral and 5/8” to 3/4” for line. Similar sized wire connectors can be used.

Individual lampholder wires (blue and red) are connected to the line.

Common wires (yellow) are connected to neutral.

These connections can be reversed. Individual to neutral and common to line.

LED Direct Wire Double-Ended Wiring Diagram 4 Lamps Instant Start Fixture

Convert Fluorescent Tubes to LED

Direct-Wire Dual-Ended LED Tube Lights 2 Lamps

Direct-Wire Dual-Ended LED Tube Lights 4 Lamps Rapid Start

Direct-Wire Single-Ended LED Tube Lights